Data List / Active Test [09/2014 - 10/2018]
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / (desired system) / Data List.
- Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Parking Brake SW Parking brake switch signal ON or OFF ON: Parking brake switch on
OFF: Parking brake switch off- Dimmer SW Dimmer switch high position signal ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position- Passing Light SW Dimmer switch high flash position (pass) signal ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position- Rear Fog Light SW Fog light switch rear position signal ON or OFF ON: Fog light switch in rear position
OFF: Fog light switch off*1 Front Fog Light SW Fog light switch front position signal ON or OFF ON: Fog light switch in front position
OFF: Fog light switch off*2 Auto Light SW Light control switch AUTO position signal ON or OFF ON: Light control switch in AUTO position
OFF: Light control switch not in AUTO position- Head Light SW (Head) Light control switch head position signal ON or OFF ON: Light control switch in head position
OFF: Light control switch not in head position- Head Light SW (Tail) Light control switch tail position signal ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch not in tail or head position- Light Sensor Illuminance Light control sensor illuminance 0 to 8191 lx Value is output according to ambient light level - Mirr-Foot-Lgt Approached/Exterior Light Approached Outside handle foot light controlled by actuation area-linked function ON or OFF Customize setting displayed - Mirr-Foot-Lgt Unlocked/Exterior Light Unlocked Outside handle foot light controlled by door unlock-linked function ON or OFF Customize setting displayed - Exterior Light (Door Open) Door open control function of the outside handle foot light control ON or OFF Customize setting displayed - Mirror Foot Light Time/Exterior Light Time Outside handle foot light lighting time 7.5 s, 15 s, 30 s or 0 s Customize setting displayed - Exterior Light Control Setting of the outside handle foot light control on/off ON or OFF Customize setting displayed - Headlight Lighting Function ECU which controls the lighting system Main Body or Lighting Sys ECU Customize setting displayed - Sensitivity Sensitivity of the automatic light control system Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed - DRL Function Setting of the DRL function on/off ON or OFF Customize setting displayed *3 Disp Ex ON Sen Ambient brightness level required to dim display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed - Disp Ex OFF Sen Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed - Light Auto OFF Delay Light auto OFF delay Off, 30 s, 60 s, or 90 s Customize setting displayed - 2 Steps Fade Out Control Function Setting of the 2 steps fade out control function on/off ON or OFF Customize setting displayed - Light up Clearance Lights at Door Unlock Function Setting of the light up parking lights at door unlock function on/off ON or OFF Customize setting displayed - The Number of DTC Number of trouble codes 0 to 255 Number of stored DTCs displayed - - *1: This item is not available even though it is displayed on the Techstream, as this vehicle is not equipped with rear fog light.
- *2: w/ Front Fog Light
- *3: w/o DRL OFF Switch
Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Turn Signal Switch (Right) Turn signal switch (right) signal ON or OFF ON: Turn signal switch (right) on
OFF: Turn signal switch (right) off- Turn Signal Switch (Left) Turn signal switch (left) signal ON or OFF ON: Turn signal switch (left) on
OFF: Turn signal switch (left) off- Hazard Flasher Switch Hazard warning signal switch signal ON or OFF ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off- Body Electrical > HL AutoLeveling > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Headlight Low Beam State Low beam headlight state ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off- Headlight High Beam State High beam headlight state ON or OFF ON: High beam headlights on
OFF: High beam headlights off- DRL Operating State Daytime running light state ON or OFF ON: Daytime running lights on
OFF: Daytime running lights off- Clearance Light State Parking light state ON or OFF ON: Parking lights on
OFF: Parking lights off- +B Voltage Value Headlight light control ECU sub-assembly power supply voltage value 0 to 19.75 V 11 to 14 V - Number Of Trouble Codes Number of trouble codes 0 to 255 Number of stored DTCs displayed -
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / (desired system) / Active Test.
- Perform the Active Test according to the display on the Techstream.
Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Daytime Running Light Daytime running lights ON/OFF - Exterior Light Outside handle foot lights ON/OFF - Taillight Relay Taillight relay ON/OFF - Headlight Relay Low beam headlights ON/OFF - Head Light Hi High beam headlights ON/OFF - Front Fog Light Relay Front fog lights ON/OFF Light control switch in tail position
*1Rear Fog Light Relay Rear fog lights ON/OFF *2 - *1: w/ Front Fog Light
- *2: This item is not available even though it is displayed on the Techstream, as this vehicle is not equipped with rear fog light.
Body Electrical > HL AutoLeveling > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Clearance Light Parking lights ON/OFF - Headlight Low Beam Low beam headlights ON/OFF - Headlight High Beam High beam headlights ON/OFF - Daytime Running Light Daytime running lights ON/OFF -