Installation [11/2017 - ]: Procedure

HINT: 

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.

1. Install the V-ribbed belt.
   Fig 1: Drive Belt Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Water Pump Assembly
   *2	No. 2 Idler Pulley Sub-assembly
   *3	Generator Assembly
   *4	Crankshaft Pulley
   *5	V-ribbed Belt Tensioner Assembly
   *6	Compressor and Magnetic Clutch Assembly

   NOTE:

   • Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.
   • Check that the V-ribbed belt is properly set to each pulley.
2. Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Correct
   *b	Incorrect

Refer to PROCEDURE - Step 106

Refer to PROCEDURE - Step 77

Refer to PROCEDURE - Step 2 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 2 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]

Refer to PROCEDURE - Step 3 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 3 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 3 [10/2022 - ]