LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (2GR-FKS) - Service Information >> Oil Pressure Switch >> Installation [11/2017 - ] >> Procedure

Installation [11/2017 - ]: Procedure

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      NOTE:
      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
      • Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
      GTY785813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Adhesive 1324
      *b Oil Inlet Port
    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

      NOTE:

      Do not start the engine for at least 1 hour after installation.

    3. Connect the engine oil pressure switch assembly connector.
  2. ADD ENGINE OIL 

    See step  7 [11/2017 - 11/2021], or see step  7 [11/2021 - ]

  3. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1 [11/2017 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]

  4. INSPECT FOR OIL LEAK 

    See step  8 [11/2017 - 11/2021], or see step  8 [11/2021 - ]

  5. INSTALL INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 77

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 2 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]

  7. INSTALL ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 3 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 3 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 3 [10/2022 - ]

scientia non olet · About LEMON Manuals