LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FKS) - Service Information >> Water Pump >> Removal [11/2017 - ] >> Procedure

Removal [11/2017 - ]: Procedure

  1. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [11/2017 - ]

  2. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [11/2017 - ] 

  3. REMOVE WIRING HARNESS CLAMP BRACKET 
    1. Disengage the clamp to disconnect the wire harness from the wiring harness clamp bracket.
      GTY812888Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and wiring harness clamp bracket from the timing chain cover assembly.
  4. REMOVE WATER PUMP PULLEY 
    1. Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.
      GTY948837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Hold
      *c Turn
    2. Remove the 4 bolts and water pump pulley.
  5. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY 
    1. Remove the bolt and No. 2 idler pulley sub-assembly.
      GTY813067Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly and water pump gasket.
      GTY813053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals