LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 450h+ Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels / Trim - Service Information (2 Of 2) >> Rocker Panel Moulding >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE REAR BUMPER ASSEMBLY 

    Refer to REMOVAL [11/2021 - ]

  2. REMOVE REAR WHEEL HOUSE FRONT PLATE 

    See step  1

  3. REMOVE QUARTER WHEEL OPENING MOULDING 

    See step  3

  4. REMOVE NO. 1 BODY OUTSIDE MOULDING PAD 

    See step  4

  5. REMOVE FENDER PANEL MUDGUARD SUB-ASSEMBLY 

    See step  2

  6. REMOVE ROCKER PANEL MOULDING COVER 
    1. GTY1053528Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure as for the Front side and Rear side.

  7. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY 
    1. GTY1053949Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Clip (A) *b Clip (B)
      1. Apply protective tape around the body rocker panel moulding assembly as shown in the illustration.
      2. Remove the 10 clips.
    2. GTY1053283Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
      1. Remove the 2 screws.
      2. Disengage the 9 clips to remove the body rocker panel moulding assembly as shown in the illustration.
scientia non olet · About LEMON Manuals