LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 450h+ Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (2 Of 2) >> Power Back Door Closer Switch >> Inspection [11/2021 - ] >> Procedure

Inspection [11/2021 - ]: Procedure

  1. INSPECT POWER BACK DOOR CONTROL SWITCH 
    1. Check the switch.
      1. Measure the resistance according to the value(s) in the table below.
        GTY1008098Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Power Back Door Control Switch)

        Standard Resistance

        Tester Connection Condition Specified Condition
        5 (CLS) - 2 (E) Pressed (On) Below 1 Ω
        5 (CLS) - 2 (E) Not pressed (Off) 10 kΩ or higher

        If the result is not as specified, replace the power back door control switch.

    2. Check that the switch illuminates.
      1. Apply auxiliary battery voltage to the switch connector and check that the power back door control switch illuminates.

        OK

        Auxiliary Battery Connection Specified Condition
        Auxiliary battery positive (+) → Terminal 6 (ILL+)
        Auxiliary battery negative (-) → Terminal 1 (ILL-)        		 Illumination illuminates

        If the result is not as specified, replace the power back door control switch.

scientia non olet · About LEMON Manuals