Caution / Notice / Hint

WARNING:

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair information.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [11/2021 - ]

To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [11/2021 - ]
To prevent the key from being locked in the vehicle, make sure to enter e-latch inspection mode and enable the manual release handle before disconnecting the cable from the negative (-) auxiliary battery terminal.
Refer to INSPECTION MODE PROCEDURE [11/2021 - ]

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

LEARNING COMPLETES WHEN VEHICLE IS DRIVEN

Effect/Inoperative Function when Necessary Procedure not Performed	Necessary Procedure	Link
Lighting System (EXT)	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.	Refer to INITIALIZATION [11/2021 - ]
Front Camera System
Adaptive High Beam System

LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY

Effect/Inoperative Function when Necessary Procedure not Performed	Necessary Procedure	Link
E-latch System Back door opener	Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.	Refer to INITIALIZATION [11/2021 - ]
Power Back Door System	Reset back door close position	Refer to INITIALIZATION [11/2021 - ]
Air Conditioning System	After the ignition switch is turned to ON, the servo motor standard position is recognized.	-

COMPONENTS (REMOVAL)

Fig 1: Charge Lid Opener Unit Removal Components (1 Of 2)

Procedure		Part Name Code
1	CHARGE LID LOCK WITH MOTOR ASSEMBLY	77030B	-	-	-
2	AC CHARGER INLET CABLE	G9081C	See step 2	-	-
3	BATTERY CHARGE PORT LID SUB-ASSEMBLY	77304A	See step 3	-	-
4	EV CHARGER LID INDICATOR ASSEMBLY	G90H0	-	-	-

Fig 2: Charge Lid Opener Unit Removal Components (2 Of 2)

Procedure		Part Name Code
5	SPOT LIGHT ASSEMBLY	81360N	-	-	-
6	BATTERY SERVICE OPENING LID SUB-ASSEMBLY	58209F	See step 6	-	-
7	CONNECTOR COVER	G9060B	-	-	-
8	BATTERY CHARGER CONNECTOR OPENING LID SUB-ASSEMBLY	58409E	See step 8	-	-