Removal [03/2022 - 03/2024]: Procedure

Refer to REMOVAL [11/2021 - 03/2024]

Refer to PROCEDURE - Step 50

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Turn the crankshaft to gain access to the 6 drive plate and torque converter assembly setting bolts and remove each drive plate and torque converter assembly setting bolt while holding the crankshaft pulley bolt with a wrench.

      HINT: 

      There will be one black-colored drive plate and torque converter assembly setting bolt.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1

   Breather Plug Sub-assembly

   *2

   Breather Plug Hose

   1. Disengage the 2 hose clamps to disconnect the breather plug hose.
   2. Using a screwdriver with its tip wrapped with protective tape, remove the breather plug hose from the No. 1 breather plug (ATM).
      NOTE:

      Be careful not to damage the No. 1 breather plug (ATM).

   3. Remove the breather plug sub-assembly from the breather plug hose.
      NOTE:

      Be careful not to damage the breather plug sub-assembly.

Refer to PROCEDURE - Step 12

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Disengage the claw, rotate the lever and disconnect the transmission wire connector.
   2. Disconnect the 2 shift control actuator assembly connectors.
   3. Disengage the wire harness clamp and disconnect the vacuum switching valve (for active control engine mount system) connector.
   4. Disconnect the rack and pinion power steering gear assembly connector.

      HINT: 

      Release the lock before rotating the lock lever.

   5. Remove the bolt and disengage the wire harness clamp to disconnect the wire harness from the rack and pinion power steering gear assembly.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 5

Refer to PROCEDURE - Step 48

Refer to PROCEDURE - Step 58

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 2

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 8 bolts and automatic transaxle assembly.
      NOTE:

      To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine assembly.

See step  16

1. Type A:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Type B:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the torque converter assembly from the automatic transaxle assembly.
      NOTE:

      Remove the torque converter assembly from the input shaft horizontally.

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 2