DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [11/2021 - 03/2022]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0011-00 is output A DTC P0011-00 and other DTCs are output B HINT:
If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 03/2022]
Result:
A
See step 2
- Read the DTCs.
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
Refer to REMOVAL [11/2021 - 03/2022]
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to NEXT Result:
NEXT
See step 3
- CLEAR DTC
- Remove the EFI NO. 1 fuse from the No. 1 engine room relay block and No. 1 junction block assembly and wait for at least 60 seconds.
HINT:
Clear the DTC without using the GTS.
- Reinstall the EFI NO. 1 fuse.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- Remove the EFI NO. 1 fuse from the No. 1 engine room relay block and No. 1 junction block assembly and wait for at least 60 seconds.
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0011-00 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [11/2021 - ]