LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Starting System - Service Information) >> Starter >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 

    Bolt 

    Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

    Nut 

    Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

  2. INSTALL FLYWHEEL HOUSING SIDE COVER 
    1. GTY1075052Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
        NOTE:
        • Make sure the claw makes a click sound, indicating that it fits tightly.
        • Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
  3. CONNECT ENGINE WIRE 
  4. INSTALL INTAKE MANIFOLD WITH INTERCOOLER ASSEMBLY 

    Refer to INSTALLATION [11/2021 - ]

  5. INSTALL AIR CLEANER HOSE ASSEMBLY 
    Refer to PROCEDURE - Step 50 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 50 [03/2023 - ]
  6. CONNECT NO. 2 VENTILATION HOSE 
    Refer to PROCEDURE - Step 51 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 51 [03/2023 - ]
  7. INSTALL AIR CLEANER ASSEMBLY 
    Refer to PROCEDURE - Step 4
  8. INSTALL INLET AIR CLEANER ASSEMBLY 
    Refer to PROCEDURE - Step 5
  9. INSTALL RADIATOR UPPER AIR GUIDE PLATE 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 5

  11. ADD COOLANT (for Intercooler) 

    Refer to PROCEDURE - Step 5

  12. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 5

  13. INSPECT FOR COOLANT LEAK (for Intercooler) 

    Refer to PROCEDURE - Step 1

  14. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  15. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 82 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 83 [03/2023 - ]

  16. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 83 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 84 [03/2023 - ]

  17. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH 
  18. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH 
  19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [11/2021 - ]

scientia non olet · About LEMON Manuals