LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Hybrid Battery Control System - Service Information (2 Of 2)) >> Combination Switch >> Inspection [11/2021 - ] >> Procedure

Inspection [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT EV DRIVE MODE SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY1063668Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (EV Drive Mode Switch (Electric Parking Brake Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        D23-4 (S) - D23-7 (E) EV drive mode switch (electric parking brake switch assembly) being pushed and held Below 50 Ω
        EV drive mode switch (electric parking brake switch assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the EV drive mode switch (electric parking brake switch assembly).

scientia non olet · About LEMON Manuals