Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NO. 2 FUEL PRESSURE SENSOR

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 2 Fuel Pressure Sensor	*2	No. 2 Fuel Pressure Sensor Holder
*a	Flat	-	-

Install a new No. 2 fuel pressure sensor to the No. 2 fuel pressure sensor holder as shown in the illustration.

INSTALL NO. 2 FUEL PRESSURE SENSOR HOLDER

Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
Connect the No. 2 fuel pressure sensor connector.

INSTALL FUEL PUMP LIFTER ASSEMBLY

See step 1
INSTALL FUEL PUMP SPACER GASKET
TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY

See step 3
TEMPORARILY INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY

See step 4
INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY

See step 5
INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY

See step 6
CONNECT FUEL TUBE SUB-ASSEMBLY

See step 7
INSTALL FUEL PIPE CLAMP
INSTALL NO. 2 WATER BY-PASS PIPE

Refer to PROCEDURE - Step 6
INSTALL EGR VALVE ASSEMBLY
Refer to INSTALLATION [11/2021 - ]
INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to INSTALLATION [11/2021 - ]
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 5
INSTALL BATTERY SERVICE COVER PLATE
INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
INSPECT FOR ENGINE OIL LEAK
See step 17
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing a No. 2 fuel pressure sensor.
  Refer to INITIALIZATION [11/2021 - ]
INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - ]