Removal [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to REMOVAL [11/2021 - ]
- REMOVE FUEL PRESSURE REGULATOR HOLDER
- REMOVE FUEL MAIN VALVE ASSEMBLY
*1 O-ring - - *a Mesh *b Mini-clip - Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.NOTE:
- Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and fuel suction tube with pump and gauge assembly.
- Do not damage the fuel suction tube with pump and gauge assembly.
- Remove the O-ring from the fuel main valve assembly.NOTE:
Do not remove the mesh and mini-clip from the fuel main valve assembly.
- Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.