LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Automatic Transaxle System - Service Information (1 Of 2)) >> Automatic Transaxle Fluid >> Replacement [11/2021 - ] >> Procedure

Replacement [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 12 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 12 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 12 [03/2024 - ]

  3. REPLACE AUTOMATIC TRANSAXLE FLUID 

    Refer to PROCEDURE - Step 3

  4. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID 

    See step  5

  5. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the GTS) 

    See step  6

  6. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the GTS) 

    See step  7

  7. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL 

    See step  8

  8. PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET 
    NOTE:

    If approximately 50% or more of the ATF has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.

    Refer to INITIALIZATION [11/2021 - ]

  9. REBUILD WORK 

    See step  10

scientia non olet · About LEMON Manuals