Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PRESSURE CONTROL VALVE ASSEMBLY
- Apply a small amount of engine oil to the O-ring of the oil pressure control valve assembly.
- Using an 8 mm socket wrench, install the oil pressure control valve assembly to the timing chain cover assembly with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
NOTE:- When reusing the oil pressure control valve assembly, inspect the O-ring.
- Make sure that the O-ring is not cracked or does not move out of place during installation.
- Connect the oil pressure control valve assembly connector.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 6 [03/2023 - ]
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 66 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 66 [03/2024 - ]