Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE OIL LEVEL SENSOR
- Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Remove any dirt or foreign matter from the engine oil level sensor connector installation hole.
- Apply a light coat of engine oil to the O-ring of the engine oil level sensor.
- Install a new clip to the engine oil level sensor.
- Connect the engine oil level sensor connector.
- Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
- INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 12 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 12 [03/2022 - 03/2024] , or refer to PROCEDURE - Step 12 [03/2024 - ] - ADD ENGINE OIL
Refer to PROCEDURE - Step 5 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 5 [03/2023 - ]
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 6 [03/2023 - ]
- CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 1 [03/2024 - ]
- INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)