Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE DOOR SCUFF PLATE ASSEMBLY LH
Refer to PROCEDURE - Step 13
REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 15
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 15 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 15 [03/2022 - 03/2024] , or refer to PROCEDURE - Step 15 [03/2024 - ]

REMOVE ACCELERATOR PEDAL (WITH SENSOR) ROD ASSEMBLY

NOTE:

Avoid physical shock to the accelerator pedal (with sensor) rod assembly.
If the accelerator pedal (with sensor) rod assembly has been struck or dropped, replace it.
Do not disassemble the accelerator pedal (with sensor) rod assembly.
The accelerator pedal (with sensor) rod assembly does not require lubrication.
Do not apply oil or other lubricants to the accelerator pedal (with sensor) rod assembly. If applied, the accelerator pedal (with sensor) rod assembly must be replaced.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE ACCELERATOR PEDAL PAD

REMOVE ACCELERATOR PEDAL

*a	Vehicle Body	-	-
	Remove in this Direction (1)		Remove in this Direction (2)

Remove the 2 bolts.
Push the accelerator pedal in the direction indicated by the arrow (1) shown in the illustration to disengage the claw.
Pull the accelerator pedal in the direction indicated by the arrow (2) shown in the illustration to remove it.