LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Control System - Service Information) >> Accelerator Pedal >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL 

    Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

  2. INSTALL ACCELERATOR PEDAL PAD 
  3. INSTALL ACCELERATOR PEDAL (WITH SENSOR) ROD ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal (with sensor) rod assembly.
    • If the accelerator pedal (with sensor) rod assembly has been struck or dropped, replace it.
    • Do not disassemble the accelerator pedal (with sensor) rod assembly.
    • The accelerator pedal (with sensor) rod assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal (with sensor) rod assembly. If applied, the accelerator pedal (with sensor) rod assembly must be replaced.

    Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 
  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 
  6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH 
scientia non olet · About LEMON Manuals