DTC P0914-2B: Gear Shift Position Circuit "A" Range/Performance Signal Cross Coupled [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (ABSOLUTE ANGLE SENSOR VALUE)
Pre-procedure1
- Turn the ignition switch to ON.
Procedure1
- Read the Data List according to the display on the GTS.
Powertrain > Hybrid Control > Data List
Tester Display Absolute Angle Sensor Value 1 Absolute Angle Sensor Value 2 Result
Result Proceed to The difference between the value of Absolute Angle Sensor Value 1 and Absolute Angle Sensor Value 2 is 1.9 or less A Other than above B Post-procedure1
- Turn the ignition switch off.
Result:
B
REPLACE SHIFT CONTROL ACTUATOR ASSEMBLY (SHIFT ACTUATOR ECU). Refer to REMOVAL [11/2021 - ]
Result:
A
See step 2
- Turn the ignition switch to ON.
- CLEAR DTC
Pre-procedure1
- Turn the ignition switch to ON.
Procedure1
- Clear the DTCs.
Powertrain > Hybrid Control > Clear DTCs
Result
Proceed to NEXT Post-procedure1
- Turn the ignition switch off.
- Disconnect the GTS.
- Leave the vehicle as is for 60 seconds or more.NOTE:
- Do not connect the GTS.
- Do not depress the brake pedal.
- Do not open/close any of the doors.
Result:
NEXT
See step 3
- Turn the ignition switch to ON.
- CHECK DTC OUTPUT (PERFORM A REPRODUCTION TEST)
Pre-procedure1
- Turn the ignition switch to ON and wait for 1 minute or more.
Procedure1
- Check for DTCs.
Powertrain > Hybrid Control > Trouble Codes
Result
Result Proceed to P0914-2B is not output A P0914-2B is output B Post-procedure1
- Turn the ignition switch off.
Result:
A
END
Result:
B
REPLACE SHIFT CONTROL ACTUATOR ASSEMBLY (SHIFT ACTUATOR ECU). Refer to REMOVAL [11/2021 - ]
- Turn the ignition switch to ON and wait for 1 minute or more.