LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Electronic A/T Shift Lever System - Diagnostic Codes & Circuit Tests) >> Electronic Shift Lever System >> DTC P085D-94: Gear Shift Control Module "A" Unexpected Operation [11/2021 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

  1. Turn the ignition switch to ON (READY).
  2. With the brake pedal depressed, change the shift state from R to D.
  3. Drive the vehicle at a speed of 40 km/h (25 mph) or more for 10 seconds or more.
  4. Stop the vehicle, and with the brake pedal depressed, change the shift state from S to N.
  5. Press the P position switch to change the shift state to P.
scientia non olet · About LEMON Manuals