Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
Torque: 43 N.m (438 kgf/cm, 32 ft.lbf)
*a Protrusion *b Cutout - Align the protrusion of the engine water pump assembly (water inlet housing) with the cutout in the sensor wire clamp.
- Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Connect the sensor wire connector.
- INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Refer to INSTALLATION [11/2021 - ]