DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [11/2021 - 03/2022]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

CLEAR DTC

Clear the DTCs.
Powertrain > Engine > Clear DTCs

Turn the ignition switch off.

Result

Proceed to
NEXT

Result:

See step 2

READ OUTPUT DTC (DTC P062F-44)

Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
Connect the cable to the negative (-) auxiliary battery terminal.
Start the engine and wait 30 seconds or more.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTCs are not output	A
DTC P062F-44 is output	B

Result:

CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [11/2021 - ]

Result:

REPLACE ECM. Refer to REMOVAL [11/2021 - ]