LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Automatic Transaxle System - Diagnostic Codes (2 Of 3)) >> Automatic Transaxle System >> DTC P1702-9F: AT Solenoids Operation Shutdown Circuit Stuck Off [11/2021 - ] >> Description

DTC P1702-9F: AT Solenoids Operation Shutdown Circuit Stuck Off [11/2021 - ]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

The ECM detects a malfunction in the current cut circuit used to transition to a fail-safe gear position.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P1702-9F AT Solenoids Operation Shutdown Circuit Stuck Off Once 5 seconds elapse after the vehicle is parked and the ignition switch is turned off, any of the following conditions is continuously met for 0.1 seconds or more during a solenoid current cut request (1-trip detection logic).
  • Solenoid (SL1) valve actual current value is 0.3 A or higher
  • Solenoid (SL2) valve actual current value is 0.3 A or higher
  • Solenoid (SL3) valve actual current value is 0.3 A or higher
  • Solenoid (SL4) valve actual current value is 0.3 A or higher
  • Solenoid (SL5) valve actual current value is 0.3 A or higher
  • Solenoid (SL6) valve actual current value is 0.3 A or higher
  • Solenoid (SLT) valve actual current value is 0.3 A or higher
  • Solenoid (SLU) valve actual current value is 0.3 A or higher
  • Solenoid (SL) valve is ON
  • Wire harness or connector
  • ECM power source circuit
  • Transmission revolution sensor (NT)
  • Transmission revolution sensor (NC)
  • Transmission wire
  • Solenoid (SL1) valve
  • Solenoid (SL2) valve
  • Solenoid (SL3) valve
  • Solenoid (SL4) valve
  • Solenoid (SL5) valve
  • Solenoid (SL6) valve
  • Solenoid (SLT) valve
  • Solenoid (SLU) valve
  • Solenoid (SL) valve
  • ECM
Does not come on DTC stored SAE Code:
P1702
DTC DETECTION CONDITION PATTERNS:

  Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5
Diagnostic Condition When a solenoid current cut request is sent after 5 seconds elapse after the vehicle is parked and the ignition switch is turned off
Malfunction Condition Solenoid (SL1) valve actual current value is 0.3 A or higher - - - -
Solenoid (SL2) valve actual current value is 0.3 A or higher - - - -
Solenoid (SL3) valve actual current value is 0.3 A or higher - - - -
Solenoid (SL4) valve actual current value is 0.3 A or higher - - - -
Solenoid (SL5) valve actual current value is 0.3 A or higher - - - -
Duration 0.1 seconds or more 0.1 seconds or more 0.1 seconds or more 0.1 seconds or more 0.1 seconds or more
Detection Logic 1 trip detection logic 1 trip detection logic 1 trip detection logic 1 trip detection logic 1 trip detection logic
DTC DETECTION CONDITION PATTERNS:

  Vehicle Condition
Pattern 6 Pattern 7 Pattern 8 Pattern 9
Diagnostic Condition When a solenoid current cut request is sent after 5 seconds elapse after the vehicle is parked and the ignition switch is turned off
Malfunction Condition Solenoid (SL6) valve actual current value is 0.3 A or higher - - -
Solenoid (SLT) valve actual current value is 0.3 A or higher - - -
Solenoid (SLU) valve actual current value is 0.3 A or higher - - -
Solenoid (SL) valve is ON - - -
Duration 0.1 seconds or more 0.1 seconds or more 0.1 seconds or more 0.1 seconds or more
Detection Logic 1 trip detection logic 1 trip detection logic 1 trip detection logic 1 trip detection logic