Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY

Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the stud bolt.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
Install the generator assembly with the bolt and 2 nuts.
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)

INSTALL ENGINE WIRE
Bolt

Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

Nut

Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
INSTALL INTERCOOLER RESERVE TANK ASSEMBLY
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
CONNECT NO. 3 INTERCOOLER COOLING WATER HOSE
CONNECT NO. 2 INTERCOOLER COOLING WATER HOSE
INSTALL V-RIBBED BELT
Refer to INSTALLATION [11/2021 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 5
ADD COOLANT (for Intercooler)
Refer to PROCEDURE - Step 5
INSPECT FOR COOLANT LEAK (for Intercooler)
Refer to PROCEDURE - Step 1
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 83 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 84 [03/2023 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - ]