Inspection [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT POWER SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Power Switch)Standard Resistance
Tester Connection Switch Condition Specified Condition 12 (SS1) - 3 (GND)
6 (SS2) - 3 (GND)
11 (SS3) - 3 (GND)Not pushed 10 kΩ or higher Pushed Below 1 Ω If the result is not as specified, replace the power switch.
- Measure the resistance according to the value(s) in the table below.
- Check the LED illumination.
- Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.
*a Component without harness connected
(Power Switch)OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 5 (SWIL)
Auxiliary battery negative (-) → Terminal 3 (GND)Illuminates If the result is not as specified, replace the power switch.
- Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.
- Check the resistance.