LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transaxle System - Diagnostic Codes (1 Of 3)) >> Automatic Transaxle System >> DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [11/2021 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Perform the universal trip to clear permanent DTCs.

    Refer to DTC CHECK / CLEAR [11/2021 - 03/2023] , or refer to DTC CHECK / CLEAR [03/2023 - ]

  • Perform registration and/or initialization when parts related to the automatic transaxle are replaced.

    Refer to PRECAUTION [11/2021 - ]

  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to BEFORE DISCONNECTING BATTERY [11/2021 - ]

  • To prevent the key from being locked in the vehicle, make sure to enter e-latch inspection mode and enable the manual release handle before disconnecting the cable from the negative (-) battery terminal.

    Refer to INSPECTION MODE PROCEDURE [11/2021 - ]