LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Smart Access System (For Start) - Diagnostic Codes & Symptom Tests (1 Of 2)) >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function, HEV Model) >> DTC B2275-11: Starter Circuit Short to Ground; DTC B2275-12: Starter Circuit Short to Battery [11/2021 - ] >> Description

DTC B2275-11: Starter Circuit Short to Ground; DTC B2275-12: Starter Circuit Short to Battery [11/2021 - ]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

This DTC is stored when a malfunction is detected in the starter circuit inside the certification ECU (smart key ECU assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2275-11 Starter Circuit Short to Ground Certification ECU (smart key ECU assembly) internal HV activation request output circuit malfunction or external circuit malfunction (1-trip detection logic*)
  • Certification ECU (smart key ECU assembly)
  • Hybrid vehicle control ECU
  • Wire harness or connector
DTC Output Confirmation Operation: 
  1. Turn the ignition switch to ON and wait 10 seconds or more, then start the hybrid control system 3 times.
B2275-12 Starter Circuit Short to Battery Certification ECU (smart key ECU assembly) internal HV activation request output circuit malfunction or external circuit malfunction (1-trip detection logic*)
  • Certification ECU (smart key ECU assembly)
  • Hybrid vehicle control ECU
  • Wire harness or connector
DTC Output Confirmation Operation: 
  1. Turn the ignition switch to ON and wait 10 seconds or more, then start the hybrid control system 3 times.
  1. *: Only detected while a malfunction is present and the ignition switch is ON.
VEHICLE CONDITION AND FAIL-SAFE FUNCTION WHEN MALFUNCTION DETECTED

Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
  • The power source mode changes to ON (READY) even though the hybrid control system is not started.
  • The power source mode does not change to ON (READY) even though the hybrid control system is started.
-
RELATED DATA LIST AND ACTIVE TEST ITEMS

DTC No. Data List and Active Test
B2275-11
B2275-12
-