DTC P2182-11: Engine Coolant Temperature Sensor 2 Circuit Short to Ground [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS)
*1 Engine Coolant Temperature Sensor (for Cylinder Head Side) *2 ECM - Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
- According to the display on the GTS, read the Data List.
Powertrain > Engine > Data List
Tester Display Coolant Temperature Sensor2 OK
GTS Display Specified Condition Coolant Temperature Sensor2 -40°C (-40°F) HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for cylinder head side).
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to REMOVAL [11/2021 - ]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE) - ECM)
- Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition V5-2 (THW2) or B49-79 (THW2) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [11/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR