DTC P0606-94: Control Module Processor Unexpected Operation [11/2021 - ]: Description
WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
The ECM calculates and compares the accelerator pedal opening angle value used for control and the value used for monitoring.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Note |
|---|---|---|---|---|---|
| P0606-94 | Control Module Processor Unexpected Operation | Condition where output of the accelerator opening angle value used for control is more excessive than that of the accelerator opening angle value used for monitoring is continuously detected for 0.2 seconds or more (1 trip detection logic). |
|
Comes on | SAE Code: P0606 |