DTC P0460-2A: Fuel Level Sensor "A" Signal Stuck In Range [11/2021 - ]: Procedure

1. Interview the customer for details about when the they refuel the vehicle.

   HINT: 

   When the fuel tank is full, if the vehicle is repeatedly driven a short distance and then refueled, the fuel sender gauge or No. 2 fuel sender gauge* output value will not change. In this case, the ECM may judge that the fuel sender gauge is stuck and store DTC P0460-2A. If the vehicle was driven in this manner, as the DTC was stored due to a user action, clear the DTCs without performing troubleshooting and return the vehicle to the customer.

   *: for AWD models

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Inspect the fuel sender gauge assembly.

   Refer to INSPECTION [11/2021 - ]

   Result

   Result	Proceed to
   OK (for 2WD models)	A
   OK (for AWD models)	B
   NG	C

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2021 - ] 

Result: 

C 

REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

Result: 

B 

See step  3

1. Remove the No. 2 fuel sender gauge assembly.

   Refer to REMOVAL [11/2021 - ]

2. Inspect the No. 2 fuel sender gauge assembly.

   Refer to INSPECTION [11/2021 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2021 - ] 

Result: 

NG 

REPLACE NO. 2 FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [11/2021 - ]