LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Smart Access System (For Entry) - Symptom Tests) >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function, HEV Model) >> Front Passenger Side Door Entry Lock and Unlock Functions do not Operate [11/2021 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When using the GTS with the ignition switch off, perform lock and unlock operations using the door control switch of the multiplex network master switch assembly at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins, and then select the vehicle model manually.

    Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Access. While using the GTS, periodically perform lock and unlock operations using the door control switch of the multiplex network master switch assembly at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • The smart access system with push-button start (for Entry Function) uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart access system with push-button start (for Entry Function) after confirming that the communication systems are functioning properly.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 03/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2023 - ]

  • Before replacing the certification ECU (smart key ECU assembly), refer to Precaution.

    Refer to PRECAUTION [11/2021 - 03/2023] , or refer to PRECAUTION [03/2023 - ]

  • Check that there are no electrical key transmitter sub-assemblies in the vehicle.
  • After repair, confirm that no DTCs are output.

HINT: 

Body Electrical > Smart Access > Utility 

Tester Display
Vehicle Control History (RoB)