Entry Unlock and Unlatch Functions do not Operate Using Kick Sensor [11/2021 - ]: Procedure

1. Read the customize setting according to the display on the multi-display.

   Refer to CUSTOMIZE PARAMETERS [11/2021 - ]

   Result

   Result	Proceed to
   The customize setting is "ON"	A
   The customize setting is "OFF"	B

Result: 

B 

PERFORM CUSTOMIZE SETTING. Refer to  CUSTOMIZE PARAMETERS [11/2021 - ] 

Result: 

A 

See step  2

1. Enter the following menus: Body Electrical / Smart Access / Utility / Vehicle Control History (RoB).

   Body Electrical > Smart Access > Utility 

   Tester Display
   Vehicle Control History (RoB)

   AUTO ENTRY WIRELESS OPERATION HISTORY (OPEN/CLOSE)
   
   

   Parameter Name	Content
   Kick Sensor Open Request Signal	The multiplex network door ECU receives kick detection signals from the kick door control sensor and sends certification requests to the certification ECU (smart key ECU assembly). If certification is OK, an open permission is sent to the multiplex network door ECU.

   Result

   Result	Proceed to
   Not output	A
   "Kick Sensor Open Request Signal" is output	B

Result: 

B 

GO TO POWER BACK DOOR SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ] 

Result: 

A 

See step  3

1. While carrying the electrical key transmitter sub-assembly, check that the entry unlock function operates when the back door opener switch assembly is operated.

   Refer to OPERATION CHECK [11/2021 - ]

   Result

   Result	Proceed to
   Entry back door open function operates	A
   Entry back door open function does not operate	B

Result: 

A 

GO TO POWER BACK DOOR SYSTEM (Power Back Door cannot be Operated Using Kick Sensor). Refer to  Power Back Door cannot be Operated Using Kick Sensor [11/2021 - ] 

Result: 

B 

GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START (Back Door Entry Unlock Function does not Operate). Refer to  Back Door Entry Unlock Function does not Operate [11/2021 - ]