LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Intake / Exhaust System - Service Information) >> Intake Manifold >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL INTAKE MANIFOLD 
    1. GTY1080220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    2. GTY1080217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. INSTALL NO. 1 TURBO PRESSURE SENSOR 
    NOTE:

    If the No. 1 turbo pressure sensor has been struck or dropped, replace it.
    1. GTY1080140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, remove the bolt and No. 1 turbo pressure sensor from the intake manifold

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  3. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY 

    Refer to INSTALLATION [11/2021 - ]

scientia non olet · About LEMON Manuals