Installation [11/2021 - 03/2023]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NO. 2 FUEL PRESSURE SENSOR

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 2 Fuel Pressure Sensor	*2	No. 2 Fuel Pressure Sensor Holder
*a	Flat	-	-

Install a new No. 2 fuel pressure sensor to the No. 2 fuel pressure sensor holder as shown in the illustration.

INSTALL NO. 2 FUEL PRESSURE SENSOR HOLDER

Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
Connect the No. 2 fuel pressure sensor connector.

INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Refer to PROCEDURE - Step 54
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 5
INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing a No. 2 fuel pressure sensor.
  Refer to INITIALIZATION [11/2021 - ]
INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - ]