DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [11/2021 - 03/2022]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
Refer to REMOVAL [11/2021 - ]
HINT:
Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to NEXT Result:
NEXT
See step 2
- CLEAR DTC
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Clear the DTCs.
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P2614-01 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [11/2021 - ]