DTC P107A-15: Fuel Rail Pressure Sensor (Low) / Fuel Rail Pressure Sensor "B" Circuit Short to Battery or Open [03/2022 - 03/2023]: Procedure

HINT: 

Make sure that the connector is properly connected. If it is not, securely connect it and check for DTCs again.

1. Disconnect the No. 2 fuel pressure sensor (for low pressure side) connector.
2. Turn the ignition switch to ON.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   B87-1 (VC) - B87-3 (E2)	Ignition switch ON	4.75 to 5.25 V
   B87-2 (PFL) - B87-3 (E2)	Ignition switch ON	0.57 to 4.88 V

4. Turn the ignition switch off and wait for at least 30 seconds.
5. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B87-3 (E2) - Body ground	Ignition switch off	Below 1 Ω
   B87-1 (VC) - B87-2 (PFL)	Ignition switch off	171 to 189 kΩ

   HINT: 

   Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor (for low pressure side).

   Refer to INITIALIZATION [11/2021 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE NO. 2 FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE). Refer to  REMOVAL [11/2021 - ] 

Result: 

NG 

See step  2

1. Disconnect the No. 2 fuel pressure sensor (for low pressure side) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B87-3 (E2) - B48-61 (EPFL)	Always	Below 1 Ω
   B87-2 (PFL) - B48-107 (PFL)	Always	Below 1 Ω
   B87-2 (PFL) or B48-107 (PFL) - Other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [11/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR