LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Control System - Diagnostic Codes (P0110-P012F)) >> SFI System >> DTC P012F-62: Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure [03/2022 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
All of the following conditions are met -
Arrive at after engine stop 5 hours or more
Engine coolant temperature -10°C (14°F) or higher
Engine oil temperature -10°C (14°F) or higher
Time after ECM started by soak timer 0.5 seconds or more
Ignition switch Off
Auxiliary battery voltage Higher than 8 V
Engine coolant temperature sensor circuit fail (P0117, P0118) Not detected
Engine oil temperature sensor circuit fail (P0197, P0198) Not detected
Soak timer fail (P2610) Not detected