DTC P012F-62: Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure [03/2022 - ]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P012F-62)
- Read the DTCs and record the Freeze Frame Data.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P012F-62 is output A DTC P012F-62 and other DTCs are output B HINT:
If any DTCs other than P012F-62 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2022 - 03/2023] , or Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2023 - 03/2024] , or Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2024 - ]
Result:
A
See step 2
- Read the DTCs and record the Freeze Frame Data.
- CHECK FREEZE FRAME DATA (COOLANT TEMPERATURE AND INTAKE AIR TEMPERATURE)
- Using the GTS, read the values displayed in the freeze frame data recorded in step 1.
Powertrain > Engine > DTC (P012F-62) > Freeze Frame Data
Tester Display Coolant Temperature Intake Air Temperature Standard
GTS Display Specified Condition Difference between the Coolant Temperature and the Intake Air Temperature Within 15°C (27°F) HINT:
- When the engine is cold, the value of the engine coolant temperature, engine oil temperature and intake air temperature should be approximately the same.
- If the result is not as specified, check that there are no heat sources such as a block heater in the engine compartment.
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [11/2021 - ]
Result:
OK
See step 3
- Using the GTS, read the values displayed in the freeze frame data recorded in step 1.
- CHECK FREEZE FRAME DATA (ENGINE OIL TEMPERATURE SENSOR AND INTAKE AIR TEMPERATURE)
- Using the GTS, read the values displayed in the freeze frame data recorded in step 1.
Powertrain > Engine > DTC (P012F-62) > Freeze Frame Data
Tester Display Engine Oil Temperature Sensor Intake Air Temperature Standard
GTS Display Specified Condition Difference between the Engine Oil Temperature Sensor and the Intake Air Temperature Within 15°C (27°F) HINT:
When the engine is cold, the value of the engine coolant temperature, engine oil temperature and intake air temperature should be approximately the same.
Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [11/2021 - ]
Result:
NG
REPLACE OIL PRESSURE AND TEMPERATURE SENSOR. Refer to REMOVAL [11/2021 - ]
- Using the GTS, read the values displayed in the freeze frame data recorded in step 1.