LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 250 FWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pan And Oil Level Sensor >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 
    1. GTY1076085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. DRAIN ENGINE OIL 

    Refer to PROCEDURE - Step 2 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 2 [03/2023 - ]

  3. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 67 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 67 [03/2022 - ]
  4. REMOVE ENGINE OIL LEVEL SENSOR 
    1. GTY1077499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the engine oil level sensor connector.
      2. Remove the clip from the engine oil level sensor.
      3. Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from engine balancer assembly.
scientia non olet · About LEMON Manuals