Installation [12/2021 - ]: Procedure

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the transfer assembly to the automatic transmission assembly with the 8 bolts.

      Torque: 40 N.m (408 kgf/cm, 30 ft.lbf) 

      NOTE:

      When installing the transfer assembly to the automatic transmission assembly, make sure that the automatic transmission assembly and oil seal do not become damaged.

Torque: 12 N.m (122 kgf/cm, 9 ft.lbf) 

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Front Mark

   -

   -

   1. Install the rear engine mounting heat insulator to the rear engine mounting insulator as shown in the illustration.
   2. Make sure that the front mark is facing in the correct direction, and then install the rear engine mounting insulator to the transfer assembly with the 4 bolts.

      Torque: 59 N.m (602 kgf/cm, 44 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Bolt

   Nut

   1. Install the No. 3 frame crossmember assembly with the 4 nuts and 4 bolts.

      Torque: 42 N.m (428 kgf/cm, 31 ft.lbf) 

      NOTE:

      Make sure to install the nuts so that they are facing the rear of the vehicle.

      HINT: 

      Hold the bolts to tighten the nuts.

   2. Connect the rear engine mounting insulator to the No. 3 frame crossmember assembly with the 4 bolts.

      Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

   3. Attach the claw and install the No. 3 engine mounting hole cover to the No. 3 frame crossmember assembly.

Refer to PROCEDURE - Step 5

Torque: 13.6 N.m (139 kgf/cm, 10 ft.lbf) 

Refer to PROCEDURE - Step 6

Refer to INSTALLATION [12/2021 - ]

Refer to INSTALLATION [12/2021 - ]