Installation [12/2021 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the cooler condenser assembly with the 2 bolts and 2 nuts.

      Bolt 

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

      Nut 

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

      NOTE:

      Do not damage the cooler condenser assembly and radiator assembly when installing the cooler condenser assembly.

      HINT: 

      If a new cooler condenser assembly is installed, add compressor oil to the condenser as follows.

      Capacity

      Add 40 cc (1.35 fl. oz)

      Compressor Oil

      Refrigerant	Compressor Oil
      HFC-134a (R134a)	ND-OIL 8 or equivalent
      HFO-1234yf (R1234yf)	ND-OIL 12 or equivalent

Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the No. 2 air conditioning and tube accessory assembly using the following procedure.

      1. Remove the vinyl tape from the No. 2 air conditioning tube and accessory assembly and connecting part of the cooler condenser assembly and then sufficiently apply compressor oil to a new O-ring and the fitting surface of the No. 2 air conditioning tube and accessory assembly.

      Compressor Oil

      Refrigerant	Compressor Oil
      HFC-134a (R134a)	ND-OIL 8 or equivalent
      HFO-1234yf (R1234yf)	ND-OIL 12 or equivalent

      2. Install the O-ring to the No. 2 air conditioning and tube accessory assembly.

      NOTE:

      Keep the O-ring and O-ring fitting surface free of foreign matter.

      3. Connect the No. 2 air conditioning and tube accessory assembly to the cooler condenser assembly with the 2 bolts.

      Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

      NOTE:

      Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed.)

Refer to PROCEDURE - Step 6

Refer to INSTALLATION [12/2021 - ]