Installation [12/2021 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Oil Inlet Port

   -

   -

   1. Apply adhesive to the area shown in the illustration.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      NOTE:

      • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.
      • Apply adhesive to the entire circumference of the thread.
   2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

      NOTE:

      Do not start the engine within 1 hour of installation.

   3. Connect the oil pressure sender gauge assembly connector.

Refer to INSTALLATION [12/2021 - ]

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 10