Installation [12/2021 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Using an 8 mm socket wrench, install the engine oil level sensor with the 2 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   2. Remove any dirt or foreign matter from the engine oil level sensor connector installation hole.
   3. Apply a light coat of engine oil to the O-ring of the engine oil level sensor.
   4. Install a new clip to the engine oil level sensor.
   5. Connect the engine oil level sensor connector.

Refer to PROCEDURE - Step 7

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 10

Refer to PROCEDURE - Step 90

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Bolt A		Bolt B
   	Install in this Direction	-	-

   1. After attaching the 2 temporary holding guides of the No. 1 engine under cover assembly to the vehicle frame, set the No. 1 engine under cover assembly to the vehicle side while pulling the engine side cover sub-assembly RH and engine side cover sub-assembly LH as shown in the illustration.
   2. Move the side of the No. 1 engine under cover assembly facing the front of the vehicle and attach the 2 temporary holding guides to the vehicle frame.
   3. Install the 5 bolts (A) and 4 bolts (B).

      for bolt (A) 

      Torque: 29 N.m (296 kgf/cm, 21 ft.lbf)