LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LX 600 Base >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Engine Oil Cooler >> Installation [12/2021 - ] >> Procedure

Installation [12/2021 - ]: Procedure

  1. INSTALL OIL COOLER O-RING 
  2. INSTALL OIL COOLER GASKET 
  3. INSTALL OIL COOLER ASSEMBLY 

    Torque: 21 N.m (214 kgf/cm, 15 ft.lbf) 

  4. INSTALL IDLER PULLEY SUB-ASSEMBLY 

    Torque: 43 N.m (438 kgf/cm, 32 ft.lbf) 

  5. INSTALL OIL FILTER RECEIVER 
    1. GTY1074485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the oil filter receiver with the 2 bolts.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      2. Attach the clamp.
  6. INSTALL OIL FILTER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  7. INSTALL NO. 1 V BELT (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) 

    Refer to INSTALLATION [12/2021 - ]

  8. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 7

  9. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 3

  10. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  11. INSPECT FOR OIL LEAK 

    Refer to PROCEDURE - Step 10

  12. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 3

  13. INSTALL NO. 2 ENGINE UNDER COVER SEAL 

    Refer to PROCEDURE - Step 11

  14. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY 
    See step  7
scientia non olet · About LEMON Manuals