Steering Pad Switch Circuit [12/2021 - ]: Procedure

Refer to INSPECTION [12/2021 - ]

Result

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  2

Refer to INSPECTION [12/2021 - ]

Result

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  3

1. Disconnect the I5 combination meter assembly connector.
2. Disconnect the I47 spiral cable sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I5-15 (MSM+) - I47-11 (+DP)	Always	Below 1 Ω
   I5-31 (MSTI) - I47-10 (+DP2)	Always	Below 1 Ω
   I5-15 (MSM+) - Other terminals and body ground	Always	10 kΩ or higher
   I5-31 (MSTI) - Other terminals and body ground	Always	10 kΩ or higher
   I47-4 (EAU) - Body ground	Always	Below 1 Ω

   Result

   Result	Proceed to
   OK	A
   NG (Spiral cable sub-assembly - combination meter assembly)	B
   NG (Spiral cable sub-assembly - body ground)	C

Result: 

A 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

B 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

C 

See step  4

1. Disconnect the I196 multi-media module receiver assembly connector.
2. Disconnect the I47 spiral cable sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I196-20 (SWG) - I47-4 (EAU)	Always	Below 1 Ω
   I196-1 (GND1) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR