DTC B1500-13: Fuel Sender Circuit Open [12/2021 - ]: Procedure
- INSPECT FUEL SENDER GAUGE ASSEMBLY
for Single Tank Type: Refer to INSPECTION [12/2021 - ]
for Double Tank Type: Refer to INSPECTION [12/2021 - ]
Result
Proceed to OK NG Result:
NG
REPLACE FUEL SENDER GAUGE ASSEMBLY
for Single Tank Type: Refer to REMOVAL [12/2021 - ]
for Double Tank Type: Refer to INSPECTION [12/2021 - ]
Result:
OK
See step 2
- INSPECT FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
Pre-procedure1
- Remove the fuel suction with pump and gauge tube assembly.
for Single Tank Type: Refer to REMOVAL [12/2021 - ]
for Double Tank Type: Refer to REMOVAL [12/2021 - ]
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition A-1 (FV) - B-1 Always Below 1 Ω A-2 (FE) - B-2 Always Below 1 Ω A-3 (FR) - B-3 Always Below 1 Ω Result
Proceed to OK NG Post-procedure1
- None
Result:
NG
REPLACE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
for Single Tank Type: Refer to REMOVAL [12/2021 - ]
for Double Tank Type: Refer to REMOVAL [12/2021 - ]
Result:
OK
See step 3
- Remove the fuel suction with pump and gauge tube assembly.
- CHECK HARNESS AND CONNECTOR (FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY - COMBINATION METER ASSEMBLY)
Pre-procedure1
- Disconnect the V8 fuel suction with pump and gauge tube assembly connector.
- Disconnect the I5 combination meter assembly connector.
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition V8-3 (FR) - I5-23 (FR) Always Below 1 Ω V8-2 (FE) - I5-17 (FE&B) Always Below 1 Ω V8-1 (FV) - I5-7 (FV) Always Below 1 Ω V8-3 (FR) or I5-23 (FR) - Other terminals and body ground Always 10 kΩ or higher V8-2 (FE) or I5-17 (FE&B) - Other terminals and body ground Always 10 kΩ or higher V8-1 (FV) or I5-7 (FV) - Other terminals and body ground Always 10 kΩ or higher Result
Proceed to OK NG Post-procedure1
- None
Result:
OK
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [12/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR