LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LS 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Hybrid Transaxle System (L310) - Service Information (1 Of 2)) >> Oil Pump Motor Controller >> Removal [10/2017 - 09/2018] >> Procedure

Removal [10/2017 - 09/2018]: Procedure

WARNING: This page is about a different car, the 2022 Lexus LS 500h, 2021 Lexus LS 500h, 2020 Lexus LS 500h, 2019 Lexus LS 500h, and 2018 Lexus LS 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to REMOVAL [10/2017 - 09/2018]

  2. REMOVE RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 3

  3. REMOVE LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 4

  4. REMOVE RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 6

  5. REMOVE NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 8

  6. REMOVE AIR CLEANER ASSEMBLY 
    1. Detach the wire harness clamp.
      GTY792479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the intake mass air flow meter connector.
    3. Loosen the hose clamp and disconnect the air cleaner hose assembly from the air cleaner assembly.
    4. Remove the air cleaner assembly from the 3 air cleaner supports.
      GTY827201Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Air Cleaner Support
  7. DISCONNECT CONNECTOR 
    1. Remove the 2 bolts.
      GTY792787Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 2 clamps and disconnect the ground wire.
    3. Detach the wire harness clamp from the oil pump motor controller bracket.
      GTY794821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pull out the lock
      *b Release the lock
      *c Rotate the lock lever
    4. Pull out the lock of the connector.
    5. Release the lock of the connector.
    6. Release the lock lever of the connector as shown in the illustration. Disconnect the connector from the oil pump motor controller.
    7. Disconnect the connector from the oil pump motor controller.
      GTY831145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Pull out the lock of the connector.
      GTY806352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pull out the lock
      *b Release the lock
      *c Rotate the lock lever
    9. Release the lock of the connector.
    10. Release the lock lever of the connector as shown in the illustration. Disconnect the connector from the oil pump motor controller.
  8. REMOVE OIL PUMP MOTOR CONTROLLER 
    NOTE:

    If the oil pump motor controller has been struck or dropped, replace it.

    1. Remove the 2 nuts and oil pump motor controller with bracket.
      GTY792778Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and oil pump motor controller bracket from the oil pump motor controller.
      GTY801647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 bolts and oil pump motor controller bracket from the oil pump motor controller.
      GTY801644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals