LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LS 500 Base, RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (2 Of 4) >> FRONT BUMPER (except Sport Package) >> Removal [10/2020 - 11/2021] >> Procedure

Removal [10/2020 - 11/2021]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [10/2020 - 11/2021]

    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to PRECAUTION [10/2020 - 10/2023]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

    WARNING:
    • After disconnecting the cable from the negative (-) battery terminal, wait for at least 60 seconds to start the operation.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 2

  5. REMOVE RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 1

  6. REMOVE LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 3

  7. REMOVE FRONT BUMPER ASSEMBLY 
    1. GTY967409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape

      Put protective tape around the front bumper assembly.

    2. Remove the 3 bolts.
      GTY967721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 clips.
      GTY967722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the other side.

    4. Remove the screw.
      GTY967372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Bumper Seal Bracket - -

      HINT: 

      Use the same procedure for the other side.

    5. Remove the front bumper seal bracket.

      HINT: 

      Use the same procedure for the other side.

    6. Remove the 8 screws.
      GTY967725Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Disconnect each connector.
      GTY967683Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Parking Support Brake System *B w/ Panoramic View Monitor System
    8. Place your hand at the positions shown in the illustration and pull in the removal direction to detach the claw.
      GTY967875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place hands here
      Remove in this Direction

      HINT: 

      Use the same procedure for the other side.

    9. Detach the claw and remove the front bumper assembly.
      GTY966655Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Headlight Cleaner System - -
      Remove in this Direction - -
    10. w/ Headlight Cleaner System:
      1. Disconnect the headlight cleaner hose.

        HINT: 

        Prepare a container before performing the procedure.

scientia non olet · About LEMON Manuals