LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Exterior Panels / Trim - Service Information (Coupe) (2 Of 2)) >> Active Rear Wing Ecu >> Installation [03/2017 - 05/2023] >> Procedure

Installation [03/2017 - 05/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 1 COMPUTER BRACKET 
    1. Attach the claw and install the No. 1 computer bracket as shown in the illustration.
      GTY802757Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
  2. INSTALL SPOILER CONTROL ECU ASSEMBLY 
    1. Install the spoiler control ECU assembly to the No. 3 deck board bracket with the nut as shown in the illustration.
      GTY834796Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
  3. INSTALL NO. 3 DECK BOARD BRACKET 
    1. Install the No. 3 deck board bracket with the 3 bolts as shown in the illustration.
      GTY816547Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
    2. Connect the 3 connectors.
  4. INSTALL INNER LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 4 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 4 [01/2021 - ]

  5. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 6 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 6 [01/2021 - ]

  6. INSTALL REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 9 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 9 [01/2021 - ]

  7. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 11 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 11 [01/2021 - ]

  8. INSTALL NO. 1 DECK BOARD 

    Refer to PROCEDURE - Step 14 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 14 [01/2021 - ]

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [03/2017 - 04/2020] , or refer to INITIALIZATION [04/2020 - 05/2023]

  10. INSTALL NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 13 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 13 [01/2021 - ]

  11. INITIALIZE ACTIVE REAR WING SYSTEM 

    Refer to INITIALIZATION [03/2017 - ]

  12. CHECK ACTIVE REAR WING SYSTEM 

    Refer to OPERATION CHECK [03/2017 - ]

scientia non olet · About LEMON Manuals