LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LC 500 2D Convertible >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System - Service Information (Convertible) (2 Of 2) >> Side Airbag Sensor >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [05/2023 - ]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to REMOVAL [05/2023 - ]

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 2

  4. REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 5

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 4

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 7

  7. REMOVE NO. 1 FRONT DOOR HOLE COVER SUB-ASSEMBLY LH 
    1. Rotate the clip knob 45° counterclockwise and remove the clip.
      GTY817703Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for Passenger Side *B for Driver Side
      *a Knob - -
      Counterclockwise - -

      HINT: 

      Use the same procedure for the other clips.

  8. REMOVE DOOR SIDE AIRBAG SENSOR LH 
    1. Check that the engine switch is off.
    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
      WARNING:
      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
      • If the airbag deploys for any reason, it may cause a serious accident.
    3. Disconnect the airbag connector.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      HINT: 

      Refer to How to Connect or Disconnect Airbag Connector:

      Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [05/2023 - ]

    4. Remove the nut.
      GTY794466Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Loosen the nut while holding the door side airbag sensor LH because the door side airbag sensor LH claw is easily damaged.
      • If the door side airbag sensor LH has been dropped, replace it with a new one.
    5. Detach the claw and remove the side airbag sensor LH.
scientia non olet · About LEMON Manuals